Also picked up the 2V gearbox, so I could start making the gearbox. Contacted some companies, but there is still one question...
Are the axles the same size? I want to swap the 2V gears onto the 3M final drive. But how can I figure out if the axles are same size? (with the gearbox closed
)E.T.K.A. only gives different gear wheels. All bearings and meshrings have the same part number.
Is this enough information to assume that other than the worm wheel (Schneckenrad), the axle is the same? (I guess so..)
The other axle, that sits directly in the clutch plate, has the other gear wheels on it (some one-piece with the axle). I guess this axle can stay together. Does the 2V has the same connection to the clutch as the 3M? This would save some work!
Hope you guys know the right answer!
